Your here: Home / Network / Hardware Specific / Airlink 101 / AR335W

Airlink 101 AR335W
Airlink 101 AR335Wa






clone of dir-300






Not Supported



NOTE: During configuration or flashing a device, the only that should be hooked to the device is the computer and power.


Fixme This section is in need of cleanup!


Serial Num. = ?
CPU Type = Atheros AR2317
MIPS Rev = ?
CPU Speed = 182MHz
Bus = ?
Flash Type = ?
Flash Chip = ?
Flash Size = 4MB
Max Firmware Size = 3735552 bytes
RAM Size = 16MB
RAM Chip = ESMT M12L128166A- 7T AZG1P52NR 0547
nvram Size = ?
Switch = IC+ IP175C LF 0636C13 VPK3980.1
Port-based vlan = ?
802.1q vlan = ?
Ethernet Port Count = 1-10/100-WAN 4-10/100-LAN Auto-MDI/MDIX
Wired Standard = IEEE 802.3/3u
boot_wait = ?
bootloader = ?
Flash Card Socket/Type = No
SD/MMC Mod Support = No
MiniPCI slots = No
PoE = No
Power = 12V/1A
Color of LEDs = ?
Size = 150 x 115 x 30mm (L x W x H)
USB = No
Serial Port = Yes
JTAG Port = Yes
Supported by TJTAG/Version = ?
Supported by dd-wrt as of = v24 rc5
dd-wrt K2.4 Support = Yes
dd-wrt K2.6 Support = No
Special Features = clone of dir-300

Radio (ath0)

Wireless Radio = Atheros AR2317 (SoC)
WLAN DSP processor = ?
Antenna Connector Type = Detachable 2dBi dipole antenna
Wireless Standard = IEEE 802.11b/g
WiFi Operating Frequency = 2.4GHz
 802.11g = 6, 9, 12, 18, 24, 36, 48, 54Mbps
 802.11b = 1, 2, 5.5, 11Mbps
Radio cor_rev = ?
Radio Capabilities = ?

Links of InterestEdit

Fixme This section is in need of cleanup!




Fixme This section is in need of cleanup!

JTAG/Serial InfoEdit


JTAG PinoutsEdit
Fixme This section is in need of cleanup!
JTAG RecoveryEdit
Fixme This section is in need JTAG Recovery Instructions!


Serial PinoutsEdit
Fixme This section is in need of cleanup!
Hyper terminal Setup in Windows XPEdit
In Windows XP, Click Start Button - All Programs - Accessories - 
   Communication - HyperTerminal
Enter a name for the connection, Click ok
Choose com port you adapter is plugged into, Click ok
 Bits per second = 115200
 Data Bits = 8
 Parity = none
 Stop bits = 1
 Flow control = none
Click ok
Click File - Save As, and select a place to save it to so you 
             don't have to enter the settings again.
Putty Setup in Windows XPEdit
After installing putty, run it
 Serial line = The COM port your using for serial (ie. COM3)
 Speed = 115200
Click on Serial under Connection
 Serial line to connect to = same as above (Serial line)
 Speed (baud) = 115200
 Data bits = 8
 Stop bits = 1
 Parity = None
 Flow control = None
Click Session
 Enter a name for your connection under saved sessions
Click Save
Click Open
Serial RecoveryEdit
Fixme This section is in need of Serial Recovery Instructions!

vlan InfoEdit

Fixme This section is in need of cleanup!


Fixme This section is in need of cleanup!

FCC PicturesEdit

Airlink 101 AR335W FCC a Airlink 101 AR335W FCC b Airlink 101 AR335W FCC c

Airlink 101 AR335W FCC d Airlink 101 AR335W FCC e Airlink 101 AR335W FCC f

Airlink 101 AR335W FCC g Airlink 101 AR335W FCC h Airlink 101 AR335W FCC i

Airlink 101 AR335W FCC j Airlink 101 AR335W FCC k


Hardware ModificationEdit

Community content is available under CC-BY-SA unless otherwise noted.