Your here: Home / Network / Hardware Specific / Askey / RT480W
 |
This article is a stub. Please help InfoDepot Wiki by expanding it, adding pictures, and improving existing text.
|
| File:Siemens_Gigaset_SE505_a.jpg |
NOTE: During configuration or flashing a device, the only that should be hooked to the device is the computer and power.
Specs[]
This section is in need of cleanup!
Platform
Serial Num. = ? FCC ID = H8NRT480W CPU Type = Broadcom BCM4712 MIPS Rev = ? CPU Speed = 200MHz Bus = ? Flash Type = Parallel Flash Chip = ? Flash Size = 4MB Max Firmware Size = 3801088 bytes RAM Size = 8MB RAM Chip = ? nvram Size = ? Switch = ADMtek ADM6998L Port-based vlan = ? 802.1q vlan = ? Ethernet Port Count = 1-WAN 4-LAN? Wired Standard = IEEE 802.3? boot_wait = ? bootloader = CFE Flash Card Socket/Type = No SD/MMC Mod Support = No MiniPCI slots = No PoE = ? Power = 12V/1A Color of LEDs = ? Size = ? USB = No (Mod to add?) Serial Port = 1 JTAG Port = No Supported by TJTAG/Version = ? Supported by dd-wrt as of = v24 micro dd-wrt K2.4 Support = ? dd-wrt K2.6 Support = ? Special Features = Gigaset SE505 v2.0
Radio (wl0)
Wireless Radio = Broadcom WLAN DSP processor = ? Antenna Connector Type = Fixed External Wireless Standard = IEEE 802.11b/g WiFi Operating Frequency = 2.4GHz 802.11g = 6, 9, 12, 18, 24, 36, 48, 54Mbps 802.11b = 1, 2, 5.5, 11Mbps Radio cor_rev = ? Radio Capabilities = ?
Links of Interest[]
This section is in need of cleanup!
Flashing[]
This section is in need of cleanup!
initial flash: use Tftp flash
Upgrading[]
This section is in need of cleanup!
Reverting[]
This section is in need of cleanup!
JTAG/Serial Info[]
JTAG[]
JTAG Pinouts[]
This section is in need of cleanup!
JTAG Recovery[]
This section is in need JTAG Recovery Instructions!
Serial[]
Serial Pinouts[]
This section is in need of cleanup!
Hyper terminal Setup in Windows XP[]
In Windows XP, Click Start Button - All Programs - Accessories -
Communication - HyperTerminal
Enter a name for the connection, Click ok
Choose com port you adapter is plugged into, Click ok
Set:
Bits per second = 115200
Data Bits = 8
Parity = none
Stop bits = 1
Flow control = none
Click ok
Click File - Save As, and select a place to save it to so you
don't have to enter the settings again.
Putty Setup in Windows XP[]
After installing putty, run it Serial line = The COM port your using for serial (ie. COM3) Speed = 115200 Click on Serial under Connection Serial line to connect to = same as above (Serial line) Speed (baud) = 115200 Data bits = 8 Stop bits = 1 Parity = None Flow control = None Click Session Enter a name for your connection under saved sessions Click Save Click Open
Serial Recovery[]
This section is in need of Serial Recovery Instructions!
USB Info[]
This section is in need of cleanup!
vlan Info[]
This section is in need of cleanup!
Pictures[]
This section is in need of cleanup!
FCC Pictures[]
Notes[]
Hardware Modification[]