Your here: Home / Network / Hardware Specific / Gateworks / Cambria GW2369
This article is a stub. Please help InfoDepot Wiki by expanding it, adding pictures, and improving existing text.
|
File:File.JPG |
NOTE: DD-WRT Activation Required.
NOTE: During configuration or flashing a device, the only that should be hooked to the device is the computer and power.
Specs[]
This section is in need of cleanup!
Platform
Serial Num. = ? FCC ID = ? CPU Type = Xscale IXP435 ? MIPS Rev = ? CPU Speed = 667MHz ? Bus = ? Flash Type = ? Flash Chip = ? Flash Size = 32MB ? Max Firmware Size = ? RAM Size = 128MB ? RAM Chip = ? nvram Size = ? Switch = ? Port-based vlan = ? 802.1q vlan = ? Ethernet Port Count = 1-WAN 1-LAN Wired Standard = IEEE 802.3? boot_wait = ? bootloader = ? Flash Card Socket/Type = Yes/Compact Flash SD/MMC Mod Support = ? MiniPCI slots = 4 ? PoE = Yes Power = 9-48 Color of LEDs = ? Size = ? USB = Yes Serial Port = Yes JTAG Port = Yes Supported by TJTAG/Version = ? Supported by dd-wrt as of = v24 sp2 - build 13023 dd-wrt K2.4 Support = ? dd-wrt K2.6 Support = ? Special Features = hardware watchdog, temp. and volt. sensor, rtc
Radio
Wireless Radio = depends on card
Links of Interest[]
Flashing[]
Upgrading[]
Reverting[]
JTAG/Serial Info[]
JTAG[]
JTAG Pinouts[]
This section is in need of cleanup!
JTAG Recovery[]
This section is in need JTAG Recovery Instructions!
Serial[]
Serial Pinouts[]
This section is in need of cleanup!
Hyper terminal Setup in Windows XP[]
In Windows XP, Click Start Button - All Programs - Accessories - Communication - HyperTerminal Enter a name for the connection, Click ok Choose com port you adapter is plugged into, Click ok Set: Bits per second = 115200 Data Bits = 8 Parity = none Stop bits = 1 Flow control = none Click ok Click File - Save As, and select a place to save it to so you don't have to enter the settings again.
Putty Setup in Windows XP[]
After installing putty, run it Serial line = The COM port your using for serial (ie. COM3) Speed = 115200 Click on Serial under Connection Serial line to connect to = same as above (Serial line) Speed (baud) = 115200 Data bits = 8 Stop bits = 1 Parity = None Flow control = None Click Session Enter a name for your connection under saved sessions Click Save Click Open
Serial Recovery[]
This section is in need of Serial Recovery Instructions!
USB Info[]
vlan Info[]
Pictures[]
FCC Pictures[]
Notes[]
Hardware Modification[]