Your here: Home / Network / Hardware Specific / Cisco-Linksys / WRT160N v2.0
This article is a stub. Please help InfoDepot Wiki by expanding it, adding pictures, and improving existing text.
|
File:Linksys_WRT160N_v2.0a.jpg |
NOTE: This divice is not supported by dd-wrt.
Specs[]
This section is in need of cleanup!
Platform
Serial Num. = CSE11 FCC ID = Q87-WRT160NV2 CPU Type = Ralink RT2880F NH47960E0 0827ST MIPS Rev = ? CPU Speed = 266MHz Bus = ? Flash Type = Parallel Flash Chip = EON EN29LV320AB-70TCP 16CG02A 0712KDA Flash Size = 4MB Max Firmware Size = ? RAM Size = 16MB RAM Chip = 2x Samsung 834 K4S641632K-UC60 Switch = RTL8306SD 86F71Q1 GB27B nvram Size = ? Port-based vlan = ? 802.1q vlan = ? Ethernet Port Count = 1-10/100-WAN 4-10/100-LAN Wired Standard = IEEE 802.3? boot_wait = ? bootloader = U-Boot Flash Card Socket/Type = No SD/MMC Mod Support = No MiniPCI slots = No PoE = No Power = 12V/1A Color of LEDs = ? Size = ? USB = No Serial Port = Yes JTAG Port = Yes (micro) Supported by TJTAG/Version = ? Special Features = ?
Radio (wl0)
Wireless Radio = Ralink RT2820L CV63560C0 0801ST WLAN DSP processor = ? Antenna Connector Type = Internal Wireless Standard = IEEE 802.11b/g/n WiFi Operating Frequency = 2.4Ghz 802.11n Draft = up to 300Mbps 802.11g = 6, 9, 12, 18, 24, 36, 48, 54Mbps 802.11b = 1, 2, 5.5, 11Mbps Radio cor_rev = ? Radio Capabilities = ?
Links of Interest[]
Flashing[]
Upgrading[]
Reverting[]
JTAG/Serial Info[]
JTAG[]
JTAG Pinouts[]
This section is in need of cleanup!
JTAG Recovery[]
This section is in need JTAG Recovery Instructions!
Serial[]
Serial Pinouts[]
This section is in need of cleanup!
Hyper terminal Setup in Windows XP[]
In Windows XP, Click Start Button - All Programs - Accessories - Communication - HyperTerminal Enter a name for the connection, Click ok Choose com port you adapter is plugged into, Click ok Set: Bits per second = 115200 Data Bits = 8 Parity = none Stop bits = 1 Flow control = none Click ok Click File - Save As, and select a place to save it to so you don't have to enter the settings again.
Putty Setup in Windows XP[]
After installing putty, run it Serial line = The COM port your using for serial (ie. COM3) Speed = 115200 Click on Serial under Connection Serial line to connect to = same as above (Serial line) Speed (baud) = 115200 Data bits = 8 Stop bits = 1 Parity = None Flow control = None Click Session Enter a name for your connection under saved sessions Click Save Click Open
Serial Recovery[]
This section is in need of Serial Recovery Instructions!
vlan Info[]
Pictures[]
FCC Pictures[]
Notes[]