Your here: Home / Network / Hardware Specific / Cisco-Linksys / Linksys WRT54G2 v1.5
This article is a stub. Please help InfoDepot Wiki by expanding it, adding pictures, and improving existing text.
|
File:Linksys_WRT54G2.jpg |
NOTE: This device is not supported by dd-wrt.
Specs[]
This section is in need of cleanup!
Platform
Serial Num. = ? FCC ID = Q87-WRT54G2V15 CPU Type = Atheros AR7240-AH1E E47132 1B 0910 MIPS Rev = ? CPU Speed = 400 MHz Bus = ? Flash Type = ? Flash Chip = Winbond W9412G61H-5 0924H 69103P50001 Flash Size = 2MB Max Firmware Size = ? RAM Size = 16MB RAM Chip = ? nvram Size = ? Switch = ? Port-based vlan = ? 802.1q vlan = ? Ethernet Port Count = ? Wired Standard = IEEE 802.3? boot_wait = ? bootloader = ? Flash Card Socket/Type = ? SD/MMC Mod Support = ? MiniPCI slots = ? PoE = ? Power = ? Color of LEDs = Green/Amber Size = ? USB = ? Serial Port = ? JTAG Port = ? Supported by TJTAG/Version = No Special Features = ?
Radio
Wireless Radio = Atheros AR9285-AL1E WLAN DSP processor = ? Antenna Connector Type = Internal Wireless Standard = IEEE 802.11b/g WiFi Operating Frequency = ? 802.11g = 6, 9, 12, 18, 24, 36, 48, 54Mbps 802.11b = 1, 2, 5.5, 11Mbps Radio cor_rev = ? Radio Capabilities = ?
Links of Interest[]
Flashing[]
Upgrading[]
Reverting[]
JTAG/Serial Info[]
JTAG[]
JTAG Pinouts[]
This section is in need of cleanup!
JTAG Recovery[]
This section is in need JTAG Recovery Instructions!
Serial[]
Serial Pinouts[]
This section is in need of cleanup!
Hyper terminal Setup in Windows XP[]
In Windows XP, Click Start Button - All Programs - Accessories - Communication - HyperTerminal Enter a name for the connection, Click ok Choose com port you adapter is plugged into, Click ok Set: Bits per second = 115200 Data Bits = 8 Parity = none Stop bits = 1 Flow control = none Click ok Click File - Save As, and select a place to save it to so you don't have to enter the settings again.
Putty Setup in Windows XP[]
After installing putty, run it Serial line = The COM port your using for serial (ie. COM3) Speed = 115200 Click on Serial under Connection Serial line to connect to = same as above (Serial line) Speed (baud) = 115200 Data bits = 8 Stop bits = 1 Parity = None Flow control = None Click Session Enter a name for your connection under saved sessions Click Save Click Open
Serial Recovery[]
This section is in need of Serial Recovery Instructions!
USB Info[]
vlan Info[]
Pictures[]
FCC Pictures[]
Notes[]
Hardware Modification[]