reee
Your here: Main Page / Network / Hardware Specific / Pentagram / P 6351
This article is a stub. Please help InfoDepot Wiki by expanding it, adding pictures, and improving existing text.
|
NOTE: This device is not supported by dd-wrt.
Specs[]
This section is in need of cleanup!
Platform
Serial Num. = ? FCC ID = ? CPU Type = RTL 8672 MIPS Rev = ? CPU Speed = ? Bus = ? Flash Type = Cmos Serial Flash [x1/x2] Flash Chip = MX25L3206E Flash Size = 32M-BIT RAM Size = 4M x 16 bit x4 Banks RAM Chip = ESMT M12L2561616A (SDRAM) Nvram Size = ? Switch = Ralink RTL 8306SD Port-based vlan = ? 802.1q vlan = ? Ethernet Port Count = 1-WAN 4-LAN Wired Standard = 10/100 Mbps boot_wait = ? bootloader = ? Flash Card Socket/Type = No SD/MMC Mod Support = No MiniPCI slots = No PoE = No Power = 12V/1A Color of LEDs = Green Size = ? USB = No Serial Port = 1 JTAG Port = 1 Supported by TJTAG/Version = ? Supported by dd-wrt as of = ? dd-wrt K2.4 Support = ? dd-wrt K2.6 Support = ? Special Features = ?
Radio
Wireless Radio = RTL 8192SU WLAN DSP processor = ? Antenna Connector Type = ? Wireless Standard = b/g/n WiFi Operating Frequency = ? 802.11n = up to 300Mbps 802.11g = 6, 9, 12, 18, 24, 36, 48, 54Mbps 802.11b = 1, 2, 5.5, 11Mbps Radio cor_rev = ? Radio Capabilities = ?
Links of Interest[]
Flashing[]
Upgrading[]
Reverting[]
JTAG/Serial Info[]
JTAG[]
JTAG Pinouts[]
This section is in need of cleanup!
JTAG Recovery[]
This section is in need JTAG Recovery Instructions!
Serial[]
Serial Pinouts[]
This section is in need of cleanup!
Hyper terminal Setup in Windows XP[]
In Windows XP, Click Start Button - All Programs - Accessories - Communication - HyperTerminal Enter a name for the connection, Click ok Choose com port you adapter is plugged into, Click ok Set: Bits per second = 115200 Data Bits = 8 Parity = none Stop bits = 1 Flow control = none Click ok Click File - Save As, and select a place to save it to so you don't have to enter the settings again.
Putty Setup in Windows XP[]
After installing putty, run it Serial line = The COM port your using for serial (ie. COM3) Speed = 115200 Click on Serial under Connection Serial line to connect to = same as above (Serial line) Speed (baud) = 115200 Data bits = 8 Stop bits = 1 Parity = None Flow control = None Click Session Enter a name for your connection under saved sessions Click Save Click Open
Serial Recovery[]
This section is in need of Serial Recovery Instructions!