Your here: Home / Network / Hardware Specific / TP-Link / TL-WR741ND v2.0
This article is a stub. Please help InfoDepot Wiki by expanding it, adding pictures, and improving existing text.
|
File:File.JPG |
NOTE: During configuration or flashing a device, the only that should be hooked to the device is the computer and power.
Specs[]
This section is in need of cleanup!
Platform
Serial Num. = ? FCC ID = TE7WR741NX CPU Type = Atheros AR7240 MIPS Rev = ? CPU Speed = 400MHz Bus = ? Flash Type = ? Flash Chip = ? Flash Size = 4MB Max Firmware Size = ? RAM Size = 32MB RAM Chip = ? nvram Size = ? Switch = ? Port-based vlan = ? 802.1q vlan = ? Ethernet Port Count = 1-10/100-WAN 4-10/100-LAN Wired Standard = IEEE 802.3? boot_wait = ? bootloader = ? Flash Card Socket/Type = ? SD/MMC Mod Support = ? MiniPCI slots = ? PoE = ? Power = 9V/.85A Color of LEDs = ? Size = ? USB = USB1.1 mod Serial Port = Yes JTAG Port = ? Supported by TJTAG/Version = ? Supported by dd-wrt as of = v.24 sp2 - build 14911 - 20100810 dd-wrt K2.4 Support = ? dd-wrt K2.6 Support = ? Special Features = ?
Radio
Wireless Radio = Atheros AR9285 @ 20dBm? 1x2 MIMO WLAN DSP processor = ? Antenna Connector Type = 5dBi Detachable Omni Directional Antenna Wireless Standard = IEEE 802.11b/g/n WiFi Operating Frequency = 2.4-2.4835GHz 802.11n = up to 150Mbps 802.11g = 6, 9, 12, 18, 24, 36, 48, 54Mbps 802.11b = 1, 2, 5.5, 11Mbps Radio cor_rev = ? Radio Capabilities = ?
Links of Interest[]
Flashing[]
Upgrading[]
Reverting[]
JTAG/Serial Info[]
JTAG[]
JTAG Pinouts[]
This section is in need of cleanup!
JTAG Recovery[]
This section is in need JTAG Recovery Instructions!
Serial[]
Serial Pinouts[]
This section is in need of cleanup!
Hyper terminal Setup in Windows XP[]
In Windows XP, Click Start Button - All Programs - Accessories - Communication - HyperTerminal Enter a name for the connection, Click ok Choose com port you adapter is plugged into, Click ok Set: Bits per second = 115200 Data Bits = 8 Parity = none Stop bits = 1 Flow control = none Click ok Click File - Save As, and select a place to save it to so you don't have to enter the settings again.
Putty Setup in Windows XP[]
After installing putty, run it Serial line = The COM port your using for serial (ie. COM3) Speed = 115200 Click on Serial under Connection Serial line to connect to = same as above (Serial line) Speed (baud) = 115200 Data bits = 8 Stop bits = 1 Parity = None Flow control = None Click Session Enter a name for your connection under saved sessions Click Save Click Open
Serial Recovery[]
This section is in need of Serial Recovery Instructions!
USB Info[]
vlan Info[]
Pictures[]
FCC Pictures[]
Notes[]