Tenda W306R v2.0

Your here: Main Page / Network / Hardware Specific / Tenda / W306R v2.0

File:File.JPG

NOTE: During configuration or flashing a device, the only that should be hooked to the device is the computer and power.

Specs

 This section is in need of cleanup!

Platform

Serial Num. = ?
FCC ID = ?
CPU Type = Ralink RT3052
MIPS Rev = ?
CPU Speed = 380MHz?
Bus = ?
Flash Type = ?
Flash Chip = KH29LV320DBTC-70G 
Flash Size = 4MB
RAM Size = 32MB
RAM Chip = W9812G61H-75
nvram = ?
Switch = ?
Port-based vlan = ?
802.1q vlan = ?
Ethernet Port Count = 4 LAN 1 WAN
Wired Standard = ?
boot_wait = ?
Bootloader = ?
CF Card Socket = ?
SD/MMC Mod Support = ?
MiniPCI slots = ?
PoE = ?
Power = ?
Color of LEDs = ?
USB = ?
Serial Port = ?
JTAG Port = ?
Supported by TJTAG/Version = ?
Supported by dd-wrt as of = ?
dd-wrt K2.4 Support = ?
dd-wrt K2.6 Support = ?
Supported by TomatoUSB as of = ?
TomatoUSB K2.4 Support = ?
TomatoUSB K2.6 Support = ?
Special Features = ?

Radio

Wireless Radio = ?
WLAN DSP processor = ?
Antenna Connector Type = ?
Wireless Standard = b/g/n
WiFi Operating Frequency = ?
 802.11n = up to 300Mbps
 802.11g = 6, 9, 12, 18, 24, 36, 48, 54Mbps
 802.11b = 1, 2, 5.5, 11Mbps
Radio cor_rev = ?
Radio Capabilities = ?

Links of Interest

 This section is in need of cleanup!

Flashing

 This section is in need of cleanup!

Upgrading

 This section is in need of cleanup!

Reverting

 This section is in need of cleanup!

JTAG/Serial Info

 This section is in need of cleanup!

JTAG

JTAG Pinouts

JTAG Recovery

 This section is in need JTAG Recovery Instructions!

Serial

Serial Pinouts

Hyper terminal Setup

In Windows XP, Click Start Button - All Programs - Accessories - 
   Communication - HyperTerminal
Enter a name for the connection, Click ok
Choose com port you adapter is plugged into, Click ok
Set:
 Bits per second = 115200
 Data Bits = 8
 Parity = none
 Stop bits = 1
 Flow control = none
Click ok
Click File - Save As, and select a place to save it to so you 
             don't have to enter the settings again.

Putty Setup

After installing putty, run it
 Serial line = The COM port your using for serial (ie. COM3)
 Speed = 115200
Click on Serial under Connection
 Serial line to connect to = same as above (Serial line)
 Speed (baud) = 115200
 Data bits = 8
 Stop bits = 1
 Parity = None
 Flow control = None
Click Session
 Enter a name for your connection under saved sessions
Click Save
Click Open

Serial Recovery

 This section is in need of Serial Recovery Instructions!

USB Info

 This section is in need of cleanup!

vlan Info

 This section is in need of cleanup!

Pictures

 This section is in need of cleanup!

FCC Pictures

 This section is in need of cleanup!