Your here: Main Page / Network / Hardware Specific / US Robotics / USR5430
This article is a stub. Please help InfoDepot Wiki by expanding it, adding pictures, and improving existing text.
|
File:File.JPG |
NOTE: During configuration or flashing a device, the only that should be hooked to the device is the computer and power.
Specs
This section is in need of cleanup!
Platform
Serial Num. = ? FCC ID = MXF-EB921201G CPU Type = Broadcom BCM4712 MIPS Rev = ? CPU Speed = 200MHz Bus = ? Flash Type = ? Flash Chip = ? Flash Size = 2MB RAM Size = 8MB RAM Chip = ? nvram = ? Switch = ? Port-based vlan = ? 802.1q vlan = ? Ethernet Port Count = 1-WAN 1-LAN Wired Standard = ? boot_wait = ? Bootloader = ? CF Card Socket = ? SD/MMC Mod Support = ? MiniPCI slots = ? PoE = ? Power = 12V/0.5A Color of LEDs = ? USB = ? Serial Port = ? JTAG Port = ? Supported by TJTAG/Version = ? Supported by dd-wrt as of = v24 micro - 9433 dd-wrt K2.4 Support = ? dd-wrt K2.6 Support = ? Supported by TomatoUSB as of = ? TomatoUSB K2.4 Support = ? TomatoUSB K2.6 Support = ? Special Features = ?
Radio
Wireless Radio = Broadcom WLAN DSP processor = ? Antenna Connector Type = ? Wireless Standard = b/g WiFi Operating Frequency = ? 802.11g = 6, 9, 12, 18, 24, 36, 48, 54Mbps 802.11b = 1, 2, 5.5, 11Mbps Radio cor_rev = ? Radio Capabilities = ?
Links of Interest
Flashing
Upgrading
Reverting
JTAG/Serial Info
This section is in need of cleanup!
JTAG
Serial
Serial Pinouts
Hyper terminal Setup
In Windows XP, Click Start Button - All Programs - Accessories - Communication - HyperTerminal Enter a name for the connection, Click ok Choose com port you adapter is plugged into, Click ok Set: Bits per second = 115200 Data Bits = 8 Parity = none Stop bits = 1 Flow control = none Click ok Click File - Save As, and select a place to save it to so you don't have to enter the settings again.
Putty Setup
After installing putty, run it Serial line = The COM port your using for serial (ie. COM3) Speed = 115200 Click on Serial under Connection Serial line to connect to = same as above (Serial line) Speed (baud) = 115200 Data bits = 8 Stop bits = 1 Parity = None Flow control = None Click Session Enter a name for your connection under saved sessions Click Save Click Open
Serial Recovery
This section is in need of Serial Recovery Instructions!